Wells and Borings
- Request/Look-up Services
- Wells and Borings Home
- EPA Request: Nitrate
- CEUs
- Construction of Wells and Borings
- Contractors
- Fees
- Laws and Rules
- Licensing
- Minnesota Well Index
- Natural Disasters
- Permits
- Publications
- Resources
- Sealing of Wells and Borings
- Special Construction Areas
- Water Quality and Testing
- Water Information
- Well Disclosure
- Well Partners
Wells Program
Related Topics
- Accredited Laboratories/Well Water Testing
- Clean Water Fund
- Contaminants in Water
- Flooded Wells
- Pesticides
- Water and Health
Environmental Health Division
Wildfire Can Damage Private Water Wells
Information for Water Well Owners After a Wildfire
As an owner of a private domestic water well that may be damaged by a wildfire, you may have some concerns about fire related impacts to your well and water system.
On this page:
Recommendation from Minnesota Department of Health
Your Water Well
Water Taste and Odors
Inside Your Home
If You've Had Loss of Water Pressure
Testing Your Well for Bacteria
Using Your Water While You Wait for Test Results
Recommendation from Minnesota Department of Health
Minnesota Department of Health (MDH) recommends the well owner perform a visual inspection of their well and water system, including the piping and plumbing that provide water to and throughout your home. Items that you should check include:
Your water well
If you see any of the following damage, you should contact a MDH-licensed well contractor to assess any damage and make repairs.
- Damage to electrical wires and connectors that supply power to your well.
- Damage to the well casing and any above-ground piping used with the well to bring water to your home.
- Damage to well houses and equipment such as chlorinators, water treatment equipment, and electronic controls.
- Damage to pressure tanks which could have been caused by exposure to excessive heat.
- Damage to storage tanks, vents, and overflow pipes.
Water taste and odors
You may notice that your water tastes or smells earthy, smoky, or burnt. If so, you may need to thoroughly flush your water lines.
Inside your home
To the extent you can, visually check the water-supply system, including plumbing, for any damage, signs of leaks, or changes in operation. You should check to see if your well and plumbing system maintained positive pressure during the fire. This can be done by simply turning on a faucet in the household to see if water flows. You should not hear any air being released from the faucet. The flow of water should be steady and uninterrupted. If you do hear air escaping from the faucet with water intermittently spurting out when it is turned on, that is an indication that your well and household plumbing had a loss of pressure and may have been damaged.
If you have had loss of water pressure
If your visual inspection shows that there was a loss of pressure or the water system has been damaged, it is likely that your water may be contaminated with bacteria. Damaged components should be repaired or replaced. Anytime a water system loses pressure, the water should be tested for the presence of bacteria before it is used for drinking or cooking. Anytime the well or water system is repaired, it should be disinfected after a repair is made and then tested to ensure the water is safe for drinking or cooking.
Go to >top.
Testing your well for bacteria
When testing drinking water for the presence of bacteria, it is necessary to collect a sample and deliver it to a MDH-certified laboratory. For a list of all MDH-certified laboratories, see Accredited Laboratory Search website or call MDH Well Management Section. You can also look in your local Yellow Pages under “Laboratories – Testing.” Bacteria samples must be collected in an approved container provided by the laboratory. When collecting a sample, follow the instructions that come with the bottle and return the sample bottle to the laboratory in the recommended time.
Using your water while you wait for test results
You can use your water for showering and flushing toilets. Take care to avoid swallowing water from showers or baths. You should not use your water for drinking or cooking purposes unless you have boiled or disinfected it. This caution includes not washing dishes or other cooking utensils in it. While you are waiting to receive the results of bacteria testing, you can boil the water you will be using for drinking and cooking for at least 1 minute at a full rolling boil.
You can also disinfect your well and water system while waiting for sample results. If the well tests positive for the presence of coliform bacteria, you should have the well and water system disinfected. Instructions for disinfecting wells can be found in the MDH Well Management Section publication: Well and Water System Disinfection For Private Wells or call MDH Well Management Section.
During an Emergency
Print Information Sheet
Wildfire Can Damage Private Water Wells (PDF)
Questions
Well Management Section
651-201-4600 or 800-383-9808
health.wells@state.mn.us
Go to > top